Saxo vts corssover loom quiz

[KierenCrawford]

Mehhhhhh

[MartinObviously]

That yellow coloured one, looks to me like the later style MAP sensor connector :y: it's in the right place and I can't think of a anything else with 3 pin connector near the ECU.

Black one right at the top (2 pin) is the connector a sort of dirty orange/brown colour? That will most likely be for the "charcoal" canister that goes under the wing above the wheel arch liner. It sends power to a small solenoid to allow fuel vapours into the inlet.


Out of interest, what are you hoping to achieve? What car are you putting this in and with what engine?

If you need to do loom splicing, REMEMBER, Peugeot wire things up by Pin number NOT colour. :)

[KierenCrawford]

Mehhhhhh

[KierenCrawford]

Mehhhhhhh

[chompy]

Two for the Altenator, oil something on the front of the block and not sure on the green one.

[MartinObviously]

The green one is for oil LEVEL sensor, and the reddish one is for the pressure switch right above it.

As chompy says, the 2 ring terminals are for the alternator.

[KierenCrawford]

Mehhhhhhh

[KierenCrawford]

Mehhhh

[MartinObviously]

I am stumped, can you zoom out a bit so I can see where on the loom it is? :P

I think the 2 ring terminals are gearbox earths, one plug for your speedo and the other for the gearbox reverse sensor.

But that leaves one I can't work out - so the other 2 could be wrong. :fuck:

[chompy]

I think the other one is the water temperature sensor. Think.

[Brendan]

Aren't those ring terminals for the starter motor?

Plugs maybe injectors and 2 inlet ones?

[Tom5190]

2 x starter ring terminals
1 x knock sensor
1 x speedo sensor

Is that a blue or green plug I cant tell from photo?

[KierenCrawford]

Mehhhh

[SGregg]

Green, injectors plug?

[Tom5190]

Black is knock, grey is speedo. Green is injectors.

How old is the engine you have? That grey MAP sensor plug wont be right for most single plug engines I'd double check it, you may find that some of the plugs don't fit.

[KierenCrawford]

Mehhhhhh

[KierenCrawford]

Menhhh

[KierenCrawford]

Mehhhhh

[Brendan]

Black/ blue rubber 4 pin is ICV
Black /green rubber 3 pin is TPS

Not sure between the other two
Throttle body heater
IAT

These are educated guesses using Autodata

[Brendan]

forum lag

[KierenCrawford]

Mehhhh

[Brendan]

Okay cheers for the help so the green/blue rubber ones are deffo ICV AND TPS just the other 2 your not sure about ?

Should be as autodata only shows them to be the only 3 & 4 pins especially with those rubber sleve type plugs and from experience as well.

[KierenCrawford]

Mahhnn

[Brendan]

What numbers are written on the wires?

[SGregg]

Blue connector is the sump, although you are missing half the plug ... same as mine :-(

[KierenCrawford]

Mehhhhh

[SGregg]

mine has, yeah