Innovate wideband

[Gabbastard]

Anyone fitted one of these to their Saxo? If so, where did you attach the three wires for the gauge? It gives examples in the instructions for power and ground, but would rather use tried and tested points as some people online have had issues when wiring.

Its the MTX-L one. Cheers :)

[Alex]

As I'd removed my stereo I wired my gauges into the connector block for that.
Has ignition live, ground and headlight live.

[DeekB]

I got one installed on my car mate, I cut the plug off the standard Lambda Sensor and used that so it was all connected into the standard loom

[DeekB]

Just realised your looking for the gauge wiring and not the sensor, Sorry!

[Gabbastard]

Just realised your looking for the gauge wiring and not the sensor, Sorry!

Haha no worries dude. You still breaking that 106? Cos I still need bits!

As I'd removed my stereo I wired my gauges into the connector block for that.
Has ignition live, ground and headlight live.

Ah the car still has its stereo, I dont think thats an option as the manual says to avoid doing it that way if the stereos being used. Cheers though man :)

[DeekB]

Haha no worries dude. You still breaking that 106? Cos I still need bits!



Ah the car still has its stereo, I dont think thats an option as the manual says to avoid doing it that way if the stereos being used. Cheers though man :)

I still got it mate yea, Sorry I've not been in touch been mega busy with work.

I should be at my mates garage next week if you are about through the day at anypoint?

[Gabbastard]

Sounds good to me man, just let me know when suits as Im off next week anyway :)

[axsaxoman]

simple answer is too find a fuse that is live when ignition is on + stays live when car is running .
yes you can use std lambda wiring --if you are sure your lom is good condition -no dodgy earths --which as all these cars are getting very old is a quite a common problem which could give you offset values