Oil pressure & Temp sensor location for aftermarket?

[MuZiZZle]

Chaps, I want to plumb in an oil pressure and temp sensor, where's the best place for these?

Cheers

[Phaeton]

If it's a oil filter that is a canister & not a paper one just get a sandwich plate

[VeiRoN]

Oil pressure to the side of the head near thermostat iirc and temperature sensor I would use the sump,either re use the original one or make a new thread

[Alex]

For temp I used a sandwich plate.
For pressure I used a remote location pipe after reading the sensors can fail from engine vibration.
It just plumbed into the block where the current one is with a banjo fitting.

[MuZiZZle]

I'm running a mocal oil cooler so a sandwich plate is an option.

I think I'll go back of sump for temp, existing pressure point for pressure and a long relocatey thing for this so it doesn't vibrate, cheers!

[Alex]

I can't remember the size or which part number it is but I used one of these, http://www.lmaautoparts.com/products/REMOTE_T-PIECE_KIT_M12/ with the banjo fitting.

I then made a bracket so it mounts to the chassis by the radiator.

[Phaeton]

This is my setup 2x sandwich plates 1 for oil cooler the other for the oil pressure switch & gauge when it arrives

http://i78.photobucket.com/albums/j81/gsx550es/Saxo%20Track%20Car/20160520_163532_1.jpg

Sent from my SM-G900F using Tapatalk

[TonyEvo]

Oil pressure to the side of the head near thermostat iirc and temperature sensor I would use the sump,either re use the original one or make a new thread
where is located?