Inlet manifold gasket size

[Nimix]

Can someone help me with the size of the gasket (the green bit) used for the inlet manifold?
https://i.ytimg.com/vi/S9-sDMGe-B0/maxresdefault.jpg

I'm going to make them on my ITB manifold to use the gasket to make it PnP :)

[Phaeton]

Might be my eyes but the only green bits I can see are you hands

[Nimix]

Might be my eyes but the only green bits I can see are you hands
Don't be silly, you can see the gaskets just like everyone else - if they are white, blue or green dosen't matter a bit..

[Ben_SaxoForte]

don't know the size but you can just buy the inlet gaskets as a set?

[Nimix]

don't know the size but you can just buy the inlet gaskets as a set?
Problem is the gaskets are circular but the holes they fit into are oval

[Phaeton]

There are no gaskets in the image do you mean the O rings?

Sent from my SM-T330 using Tapatalk

[Ben_SaxoForte]

I'm pretty sure the round o rings just take the shape of the inlet once installed

[axsaxoman]

correct --if worried at all a little smear of sealer behind them is all that is needed--not usually a problem re-using them --not "o rings " they are shaped seals