VTS in 1.4 Berlingo

[Cooper2017]

Hi all, New on here. I'm doing a berlingo 1.4 converted to a VTS from a C2. I have changed the inlet manifold to the cable throttle off an earlier VTS and using the 1.4 gearbox due to the VTS box being hydraulic. I have both engine looms and ECUs. In regards to wiring the engine up what procedure needs to be done? Do I have to splice the berlingo body loom to the C2 engine? Any help would be great to make my life easier.

Cheers :y:

[welshpug]

depends what year the berlingo is.

if its a multiplex vehicle then I would imagine the best route is to use the C2 loom and ecu, there's high chance it'll just plug in.

using the C2 inlet will give more power most likely also, use a hdi throttle potentiometer.

[Cooper2017]

The berlingo is a 2002 panel van. Ive got the C2 loom and ECU so ill have to look into it

[Chipwizards]

You can buy a stock Berlingo with an NFU already fitted.

[Mickswan]

I had the 1.6 Multispace. Was slow as shit.

[Chipwizards]

I had the 1.6 Multispace. Was slow as shit.

:-D

Just needs boost....