Saxo rear wheel bearings

[Jonathancilia]

Hi im in the process of changing my rear drums and shoes, and i need to install new bearings to the drums,

Do i need 52mm or 51mm wheel bearings diameter?

Mine is no ABS and 4 studs 1.5 diesel

Sent from my VFD 510 using Tapatalk

[Slevan_7]

Just had a look in the Haynes manual it doesn't tell me anything, what I always do is get a set of calipers on the bearing before removal and after, you're ready going to have to find this out on your own mate not a huge amount of people on hear anymore.

Sent from my F8331 using Tapatalk

[Jonathancilia]

I understand, i only asked because im not going to remove the old one because the drum is junk

I saw that there are 2 sizes, one 56mm and one 52mm. But i think i need the 52mm then because i measured with a set of calipers even if i had to eyeball it because the calipers wont go in all the way

Sent from my VFD 510 using Tapatalk

[Slevan_7]

If it's stuck I take it your not using it at the moment, just pull the bearing, I'm guessing if you'd already had a set on there saying 52mm a 4mm difference would be a huge amount of difference, I would just order 52mm bearing its not like there expensive really.

Sent from my F8331 using Tapatalk

[Jonathancilia]

Thats what i will do thanks :)

Sent from my VFD 510 using Tapatalk

[Slevan_7]

I just had to find out what crankshaft seals I needed, I was 0.2mm off on the calipers so it's easy really. I know the feeling worrying about ordering the wrong thing, was all good in the end.

Sent from my F8331 using Tapatalk

[Jonathancilia]

Yeah especially when ordering online you have to be super careful, because sometimes you give them all the correct information and they still send you the wrong parts hehe :)

Sent from my VFD 510 using Tapatalk