markj_vtr
22nd March 2021, 23:47
So It's been about 5 years since my VTS died and I've still got a shed full of Saxo bits including but not limited to a Rotrex C30-74 (The only thing I'm missing for a rebuild is an ECU)
I've been looking for a another VTS but it's got to be black (don't judge me) and mk2 (mainly because I cut up a perfectly good pair of angle eyes to accommodate the Rotrex's pully) but I never seem to be able find one.
I've been thinking of getting a VTR as they seem to still be a bit more common.
Supercharging a VTR, is it really as bad an idea as it sounds in my head?
I've seen threads from back in the day of people turboing them and surely once you start going down the forced induction route an extra 8v can't be that much of a game changer (and yes I will probably miss the ABS and electric mirrors)
While I'm embarrassing myself by asking noob questions I might as well try this aswell, if I did get a VTR how nicely would a 16v head go on? I guessing it would only really need the head and loom? Injectors, rad, ECU will all be getting swapped out anyway. Will the interior and engine looms have the same plugs? or will the soldering iron have to come out? and if I swap out both looms there's nothing to stop me from swapping a couple of VTS mcpherson struts to get ABS???? Compression ratio issues? I don't have any fordged pistons.
Well I think I've talked myself out of pissing around trying to put a 16v head on but comments and suggestions would be most appreciated.
https://www.facebook.com/photo/?fbid=515401362955103&set=a.381198603042047
I've been looking for a another VTS but it's got to be black (don't judge me) and mk2 (mainly because I cut up a perfectly good pair of angle eyes to accommodate the Rotrex's pully) but I never seem to be able find one.
I've been thinking of getting a VTR as they seem to still be a bit more common.
Supercharging a VTR, is it really as bad an idea as it sounds in my head?
I've seen threads from back in the day of people turboing them and surely once you start going down the forced induction route an extra 8v can't be that much of a game changer (and yes I will probably miss the ABS and electric mirrors)
While I'm embarrassing myself by asking noob questions I might as well try this aswell, if I did get a VTR how nicely would a 16v head go on? I guessing it would only really need the head and loom? Injectors, rad, ECU will all be getting swapped out anyway. Will the interior and engine looms have the same plugs? or will the soldering iron have to come out? and if I swap out both looms there's nothing to stop me from swapping a couple of VTS mcpherson struts to get ABS???? Compression ratio issues? I don't have any fordged pistons.
Well I think I've talked myself out of pissing around trying to put a 16v head on but comments and suggestions would be most appreciated.
https://www.facebook.com/photo/?fbid=515401362955103&set=a.381198603042047