cold air feed?

[cus_da_saxo_kid]

Just bought a K&N open air filter for my saxo 1.1 2002 and it sounds amazing! :) , but I would like to move it to the front of the engine bay to get 'cold' air. Where can I get piping from for this?
Cheers

[Josh_Phipps]

http://www.viper-performance.co.uk/products.php?%20cat=58

[S34MER]

you could just give the induction kit a cold air feed matey, would be easier than trying to mount the induction kit nearer the front of the engine bay!

[VTS_16v_Boy]

Check out www.espdesign.co.uk

They sell Silicone Hoses and Ali tubing. Take your time to measure everythin twice so you have everythin you need and don't end up with a pipe thats alittle bit too short.

I saw an induction kit on eBay awhile ago that located the cone behind the headlight and was feed by cold air around the headlight I missed the biddin and regretted it, you could try that and just bring another cold air feed from the bottom of the car upto the cone.

[cus_da_saxo_kid]

Thats true, so where could I get piping for this from? I know it sounds a stupid question. Thanks

[S34MER]

you can get it from anywhere matey, halfords sell it, just ask for a cold air feed pipe for you induction kit, and they'll sort you out!

[VTS_16v_Boy]

S34MER is right halfords do tubin in different lengths, but also Dont tell anyone (& if you do buy one keep it quite) in the Ripspeed section they sell cold air feeds with the plastic entry rings which if you cut a small hole in the lower part of your grill or bumper then you will get cold air direct from the front of the car plus the faster you go - the fast the cold air will be forced into the cold air feed.

Like I said, take your time, have a good hard look at what sits where, scetch afew pics on paper then get stuck in :-)

Remember - Measure twice, cut once :-)