PDA

View Full Version : Tappy VTS


clarkey2r
23rd March 2007, 12:04
Hi all

I have got a 1999 T reg VTS. My engine has been in the garage for a few bits drive shaft seal etc. I asked the bloke do you think it sounds a bit tappy? He said yes. I asked him what he thought and he said the head might need replacing 750-800 quid all in!! Is this expensive? Any other possibilities of what the tap could be? It is only really noticeable when cold. It’s been like it for a while now. Will it go pop?

Tobs
23rd March 2007, 12:07
its the cams

or even bigger the big ends are knocking (bearing are worn)

how loud is the tapping? loud loud or just noticeable?

clarkey2r
23rd March 2007, 12:10
under the bonnet its loud. you can here it in the car but only just

CampDavid
23rd March 2007, 12:11
I'll put a tenner on it that a spark plug is loose. Take the coil off and tighten all the sparks to the right torque load.

That should sort it :)

MaRiO89
23rd March 2007, 12:16
I'll put a tenner on it that a spark plug is loose. Take the coil off and tighten all the sparks to the right torque load.

That should sort it :)


Agree'd, very rare for big end bearings etc to go on TU engines unless they have been neglected.. :y:

MaRiO89
23rd March 2007, 12:18
Also if it was the big end going/gone it would be knocking when you rev it..

Tobs
23rd March 2007, 12:22
well if its a small knocking noise then its not manger

im use to listening to loud noises at college from all the old shitters

clarkey2r
23rd March 2007, 12:27
will have a look at the spark plugs at the weekend. if it still there shall i scrap it?


only joking but what will it be then?

MaRiO89
23rd March 2007, 12:28
im use to listening to loud noises at college from all the old shitters

HAHAHA, that made me laugh, i dont know why..:clapping:

MaRiO89
23rd March 2007, 12:29
will have a look at the spark plugs at the weekend. if it still there shall i scrap it?


only joking but what will it be then?

If its not the plugs (will be the plugs) then you would have to speak to a mechanic as none of us on here can here it.. lol.

CampDavid
23rd March 2007, 12:29
will have a look at the spark plugs at the weekend. if it still there shall i scrap it?


only joking but what will it be then?

A lifter most likely, but lets see if it's the spark first

Tobs
23rd March 2007, 12:33
A lifter most likely, but lets see if it's the spark first

lifter do u mean cam followers?

VTS123
23rd March 2007, 13:26
Hydraulic lifter. If it's one of them try an oil and filter change before spending a lot of dosh. They like new oil.

clarkey2r
23rd March 2007, 13:51
just had new oil and filter

woodsy
23rd March 2007, 13:56
what oil you used

clarkey2r
23rd March 2007, 14:22
castrol 5w-40 iirc

MaRiO89
23rd March 2007, 14:25
Shuda used castrol edge sport 0w-40, good stuff.. :)

CampDavid
23rd March 2007, 14:33
Makes no odds, 5w40 is good enough

Tobs
23rd March 2007, 18:30
the only thing that is the commom cause of rattleing in the head will be the cam followers.

or the oil

MaRiO89
24th March 2007, 00:47
Makes no odds, 5w40 is good enough

Was only messing mate.. jeez..:panic:

williamsvts
24th March 2007, 12:13
injectors make a funny noise after a while on these for some reason.

clarkey2r
26th March 2007, 18:54
Spoke the mechanic on fri night and he said it wont be a lifter because its too much of a deep knock. He did say its not really urgent, but just keep an ear out to see if it gets louder. How much would it cost for a new head and maybe cams? Could it be done in a weekend?

ckings6056
26th March 2007, 22:25
it sounds like the lifters to me or possibly the cam followers.

these can get pretty loud depending on how long they are left for.....