quickest way of taking out my inlet mainfold on my vtr??
 

as above

there are 6 x 10mm nuts on the manifold. 3 each side. 2 on top and one underneath. bottom ones r a bit of a pain 2 get to. just undo them. but u will need 2 take of da carbaretor. and disconnect accelerator cable 2 take manifold completely out mate.

cheers, what about the fuel rail?

yea mate u will need to remove it. what are u doing to your manifold anyway?

trying to fit a s1 rallye inlet and tb, i know theres guide's but im still abit stuck on one or two bits

mainly the electrically bits

should be fun. well good luck mate

hopefully all goes well, cheers