[kxhaz]

well over the last cuopple of days havent realy odne all that much but here is what i have done

from the last updat just hade to tacke a fue more hoses, wires ect off and the head came strate out.






gasket was well and truly dead



then i striped down the head




then i took out colets, springs and valves.




then i took al the cr*p out of the zorst ports





and then took out valve stem seels



now its ready to go to be machined cleen and flat. so i took off the sump and started to take out the pistons and realised the conrod dont fit through the liners so may take the liners out or may justnot bother with the rings.

thanks