[kxhaz]

right wel better do an update havent done much over the last week and a bit as i started my new job but lastnight i went down the work shop and started rebuilding my head.

so this is what the head looked like when i got it back after being machined flat and clean.




also my bits arived. (head set, head bolts and sump gasket)



so then i cleened up the valves







then i recut my valves at seats. (no pik)

then put my new inlet and zorst manafold studs on.




then in went the valves, springs and cam shaft.



then on went everything els




and thats how i left it