Quote:
Originally Posted by Alexywhite
I have what i think is a successful design. I designed the whole thing in Solidworks (I have a student copy, because i'm at uni) and then made some mock up parts from cardboard. Everything seemed to fit fine. My design made it so that you would have to relocate the horn and replace one of the engine mount studs with a bolt.
I dont have a progress thread, but i have designed every part for the inlet mani and reducers for a GSXR 1000 K7 bike body setup. I just really need to get round to getting it made.
I had another look at your manifold and it looks to me that it may foul on the electronic rail for the injectors. However, im sure that the guys that made it tested it to fit. Or i might have a different electronics rail than you.
Would it be possible for you to give me some rough measurements of your mani? I'll send you aan assembly drawing of my design if you would like to compare.
Cheers
Alex
|
Sounds pretty cool, I was going to get my brother to design the mani as I wasn't sure with Colin made them for this engine but he did so I thought I'd save the hassle.
To be honest from the top of my head I can't see why you would have to change engine mount bolts as there isn't a mount no were near it is there? Same with the horn?! (May just be me being a tool)
Yeah I wouldn't mind if you let me know what measurements you would like...might be easier if you did forward me your design but mark up which measurements you would like
Cheers,
Wes