Will this fit - magnex backbox on standard centre section

[VTR_Craig]

I apologise for another will it fit thread.

Will this backbox fit a standard centre section on a mk2 VTR?

http://www.saxperience.com/forum/sho...d.php?t=138199

Thanks in advance

[OLLYVTS]

Iirc you will need a reducer to get it to fit as the pipe on the magnex back box is 2" and the standard middle section is small than that.

[VTR_Craig]

Any ideas where i can get these from?

thanks for the reply.. repped

[kevinvanj]

Hey sorry found this thread, dunno if i am on about the same thing but if u look in the pic the magnex pipe has a smaller pipe with slits in it that goes inside the pipe thus reducing it , this came with the back box and is still connected

Hope this helps

[saxokid100]

Well it shud go on fine now mate.....

[VTR_Craig]

Just got some pictures of my standard exhaust.

There are no joins between the centre section right upto the backbox. the join itself is at the backbox - see pictures.

Therefore how will this fit?







Thanks

[saxokid100]

You have to cut the centre pipe back little bit mate!! so you can slide your magnex over the cut centre pipe,and then clamp it up with new rap round clamp....

[saxokid100]

I got my clamp,from Halfords mate.....

[VTR_Craig]

Is that what you have to do to get a magnex to fit? lol

[kevinvanj]

yeah unfortunately you do bit if u keep the rest of the piece u cut off unlike me then u can put ur standard back on again without purchasing new pipe

[saxokid100]

Can be a pain!! easyer to have the magnex middle pipe too!! go together perfect..with no leaks matey....

[VTR_Craig]

Cheers fo your help guys. repped