VTR Alloys on 1.1 Forte

[laser402]

Just been trying to fit these on my saxo but hasnt been going to well.

Just tried to fit the nearside VTR alloy on and found it to be a VERY snug fit onto the hub, The rear's seem to go on fine though?!? I hope the other front alloy goes on better. I assume VTR Alloys do directly fit on a 1.1 Forte Mk2?

The alloys on it were some aftermarket ones and i assume had shorter wheel nuts? as they seem to only turn alil way before they are tight

Are the VTR wheel nuts 35mm long? I currently have 25mm ones.

Also when can I get these? Halfords? Motor spares shop? I just need some urgently!!!

Thanks Guys =]

[Payney]

VTR alloys should be a straight fit pal... You do need the bolts to fit though, Halfords don't do a set only locking nuts.. Cost you about £35 from there... Better off looking on eBay, or have a browse in the for sale section.

[Mark51p]

you need to have about 7 full turns on the wheel bolts. the standard vtr bolts are 35mm long and 23-25mm of that goes into the hub.

they should be a straight fit aslong as you dont have a 3 stud hub.
i have a few bolts froma vtr laying around if you wanted to try one, PM me?

[Noddy]

the VTR alloys as said, will for certain fit onto your car, that i can guarantee.... you'll need to have flat seated bolts though, not the tapered ones... easily found on ebay....

[laser402]

Thanks for the reply guys.

Could someone post a picture of one or ebay link as I cant find them anywhere?!?

Kinda need to get them today as the insurance only allows the vtr alloys not the aftermarket ones. I want to Drive!!!

Criteria: 35mm long
Flat Head (not tapered)

Anyone think of a shop I can buy these. Breakers? Motor Spares?

Thanks