Sqeeking

[sexysaxogirl]

when i get in and out my car there is a sqeek from the rear i think it might be my torsion bar any idea's

[Andy-Lee]

could be up rear brakes, if your handbrake is on ur pads are locked on to the disk but when you get in the car goes down thus moving the disc through the pads slightly possibly causing your squeek

[sexysaxogirl]

anyone else have any idea's

[Saxo_Scott]

sounds like the arb

Originally Posted by boz

ok, if this is a squeak or clunk when going over bumps and when cornering?

it sounds like the rear anti roll bar.

you can solve this buy jacking up the rear passenger side
remove the wheel
you will see the end plate (oval'ish)
remove the plastic plug from the centre of this plate using a torx bit.
then you will need a longish m8 bolt, you can use a manifold stud if you have one.
place a few washers that are bigger than the hole, onto the bolt, screw the bolt into the anti roll bar via the hole in the oval plate.
screw this in, this will then put your anti-roll bar towards the passenegr side and stop the squeak. you can also apply more grease into the hole in the oval plate, using a grease gun.

re-fit the plastic plug
re-fit wheel
lower car
enjoy a squeak free ride

i have done this a few times lol

if you look at a lowering guide, you will see the areas i mean in the pictures.

you are using the washers on the bolt, to release and opposite force onto to anti roll bar when you screw the bolt in

[16vax]

could be a few things as above brakes arb bolts loose or at worst beam starting wear, dry up

colin

[sammyd]

ive the same problem but im a fat bastard so now i know why lol only messing it could maybe be the shocks needing bit of oil or somthing on them

[Phsyco_Paff]

had ezact same problem just needed to copper grease the rear pads

[coleman258]

If it does it when the handbrake isnt on then mine did this and i got under the car and soaked it in wd40, done the job.