electric window motor cable
Following a minor accident whereby the passenger door took a knock I figured it would pop out if I could get at it from the inside. I removed door card and noticed the only place I could get at the bump would require taking off the window motor which I did and then successfully tapped out the dent ,problem solved.
But trying to get the cable back on to the black wheel part of the regulator was a bit of a nightmare.Has anybody done this successfully(maybe just repaired a broken cable) or is it necessary to change the whole assembly . I had to put the door card back and tie up the cable to stop the window coming down as the wife needed he car for work . I had slipped the cables out of their guides and tried to wind them back with the switch but they seemed to just unwind further. Any ideas /suggestions appreciated.
|
Threaded Mode