After looking at my xsi engine it appears to differ from the vtr engine in the cooling side of things.
Has anyone got any pictures of the routing of the heater matrix feed/return pipes from the back of the block? It appears the VTR had an adaptor (the one with the dust cap like bleed screw) with just one pipe leading out of it that goes to the matrix feed. This left me unsure of what to do with the return?
On the xsi however there are two pipes leading into the bleed screw adaptor but the second feed on this adaptor was plugged so I removed the plug, to open up the return feed, and put the pipe on!
Where should the matrix return feed go with the VTR setup (adaptor with one pipe takeoff on it)?
My setup should work if my theory is correct, its feeding and returning from the same point
Pictures might help with this one I feel, see below
Heater matrix pipes
Linear Mode
