final torsion bar help - one is out! - Saxperience

VillicusVTR · 12th September 2011, 18:10

Finally after fucking hours and days I have one bar out, now im measuring the height to put it back together, when measuring the normal height what point do u measure from on the car, in the guide it starts from the bottom of the shock....also because im wank at maths, i want to go 55mm, so that would be 19.5cm alltogether right???

Ben_SaxoForte · 12th September 2011, 20:04

it doesnt really matter where you measure from as long as you measure from the same place on both sides just find somewhere solid thats the same both sides of the car, and yeah that sounds right. or you could even measure from the floor to the bottom of the brake disk and take it up from there

jonnyquiksilver · 19th September 2011, 16:48

i always measure from centre of hub to the inside of your arch on both sides, no worries about car not being jacked up level then