push start button

[megslad]

I know theres a thread for this but in that thread they are using a relay.
All I want is the colour of a feed wire into my switch and output.
So i can wire it without any need for relays

Thanks

[Stevo123]

The relay is there to handle a higher current than your swith will/will not handle that's all.

Use a multimeter and find the wire on the ignition that gose +12 when the key is fully turned round into the starting position. Then need to link the feed to ignition to this wire with your switch (or relay) in the middle of it.

standard:
ign feed--------[ign barrell switch]---------to starter motor solenoid

what you want:
ign feed--------[your switch]--------------to starter motor solenoid

[megslad]

ta thats what i wanted to know, ill go for the relay then jst in case