Saxo VTS Siezed Cams

[Newbloke]

Hi Folks

I'm beginning to not love my VTS anymore after it came to a grinding halt!!!

I have recently fitted new cambelt, tensioner and water pump, so when it stopped I reckoned I had goofed the belt tension of something and broken a belt.

Anyway after stripping the top end I found that the belt was fine, but the inlet cam had seized, which jumped the belt and of bent a few valves, lovely!!! NOT

On closer inspection I thought I had pushed the camshaft oil seals in too far back into the head, which looked like they were blocking an oilway at the front of the cam.

Ok, so I thought that was the problem, put it all back together with a spare head and carefully set the oils seals further forward.

2 mins running and it seized again!!!!!!!!!!!!!! fcuk

I don't remember the oil light coming on when it first seized, but that said I was only going slow, and I know that sickening feeling/sound of a belt breakage and just pulled over.

So, can the oil pump chain snap? Do Oil pumps just stop working.

HELP.

[greyjasper51]

If the pressure light hadnt come on then there must be a blockage in the block somewhere... Starving the feed to the head but keeping pressure in the block by the sensor... Or the sensor dont work...

[greyjasper51]

Oh...

Yes the oil pump chains can snap, not normal but have seen it before but will cause a loss of block oil pressure... And yes they can stop working but a loss of block oil pressure will result again

[stevo67]

Originally Posted by greyjasper51

Oh...

Yes the oil pump chains can snap, not normal but have seen it before but will cause a loss of block oil pressure... And yes they can stop working but a loss of block oil pressure will result again

Do the pumps ever get blocked?

[Newbloke]

Thanks, current plan is to take the cams out and crank the motor and see if anything is going up to the head, if not off with the sump.

Cheers
C

[greyjasper51]

Its possible, but surely the oil changes will be more regular than that... Filter would block first

[KrisB]

Don't forget, there's pressure and there's flow.

Cams are under the most strain at idle.

[Newbloke]

Hmm, both seizes were at low revs or idle, so you may have something there!
I have just fitted a new quality oil filter, so maybe the strainer to the pump is blocked?
??