After scratching my head a bit over trying to source extended flat seated wheel bolts, i've come to the conclusion I'd probably be as well looking in to a stud and nut conversion.
Have done a bit of searching on the subject, but most of the content I can find is a few years old now so i'm not sure whether the suppliers mentioned are still going (madaxgt seems to have been the best shout - does he still deal with these?)
So....... is it still the case I should steer clear of the ones you can find on Rally Design for around a pound a stud?
Where else can I source good ones with flat seated nuts that'll accomodate oem wheels?
What length of stud should I be looking at to allow introduction of a spacer (10-15mm)??
Any current advice and recommendations appreicated