SEATS and wiring problems help asap - Saxperience

melly · 31st January 2007, 19:07

just fitted gti leather to my mk2vts and the gti leather came withe the normal plugs for the pretensioners, my car though had different style pluggs, i then chopped both plugs off and tried to figure out what wire connects 2 what as tere not the same colour, so now my airbag light is flashing, any help would be ace and a rep left pm 2 cheers

Mark51^p · 31st January 2007, 19:22

why dont you put the old plugs back on and use the plugs from your old seats

melly · 31st January 2007, 19:37

coz ive sold the old seats

gibs-rallye · 31st January 2007, 19:40

get urself to a scrappy and cut the plugs of a vts there but leave some wire on and soldier the wires together. hey presto jobs a good un

kenny · 31st January 2007, 19:46

agreed with above or cut both ends and use connectors to fit them together.

melly · 31st January 2007, 19:52

thats what i have dun used connectors and joined them together ive also tried the wires everyway i can co but sill flashing

gibs-rallye · 31st January 2007, 19:54

u tried resetting the ecu???

melly · 31st January 2007, 20:12

no mate didnt no u could do that?

Mark51^p · 31st January 2007, 20:28

dont think you can, im sure its a Citroen job. like when you have an error that comes up on their Diagnostic machine they reset the ECU to get rid of the error

furioAL^m · 31st January 2007, 20:39

Have you managed to find yourself some saxo plugs? if not pm me your address and i'll send you some as i have a set left over from when i changed my interior.. they have some wire still attached so you could give them a try

It may of course not be your pretensioners that have the dodgy connection.. check the junction of the orange wires underneath your ignition cover (below steering wheel)

Cheers
Alex

EDIT: alternatively you could connect the citroen pretensioners to the pug seats..?

melly · 31st January 2007, 21:05

well it all wored fine b4 i put new seats in basically now all i have is wires joined by electrical connectors, the original saxo plugs were neva there anyway, and i had to chop the 106 ones off anyway so im stuck with just wires

gibs-rallye · 31st January 2007, 23:14

well u can reset the 106 when u've had certain problems.

all u do is disconnect negative battery treminal then unplug ecu leave for an hour. then plug the ecu in and reconnect the battery. let it idle for 10 mins. job sorted.

thought the saxo's may have been the same but i could very well be wrong