inlet manifold problem vts - Saxperience

hon · 22nd May 2010, 00:08

found a hose snapped off just underneath the left side of inlet manifold box, the hose runs over side of the engine.

How do i take the inlet manifold box off, i took the 3 screws off the top, but still wont come off, any helper how to and what the hose do?

Pug106-GTI · 22nd May 2010, 00:10

there is another two under the inlet mate at the bottom of it left and right

hon · 22nd May 2010, 00:13

Quote:

Originally Posted by Pug106-GTI

there is another two under the inlet mate at the bottom of it left and right

are they hard to un do? do you what that broken pipe do by any chance? thanks

Simo^p · 22nd May 2010, 00:16

The hose your describing sounds like the one that runs to the charcoal canister under the drivers side wing.

The pipe is on quick release fittings under the manifold. If you press and pull you should be able to disconnect the pipe fine. You shouldn't need to remove the inlet manifold to fix this.

hon · 22nd May 2010, 00:40

Quote:

Originally Posted by Simo

The hose your describing sounds like the one that runs to the charcoal canister under the drivers side wing.

The pipe is on quick release fittings under the manifold. If you press and pull you should be able to disconnect the pipe fine. You shouldn't need to remove the inlet manifold to fix this.

its on the passenger side, the hose run between the cam cover and the engine cover then down some where.