Quote:
Originally Posted by gdf106
That DP manifold is a nice looking bit of kit!
|
It's an off the shelf solution to a problem/need. If I were starting again, I'd probably still run this inlet but with a smaller throttle body. 70mm is much too big even at high power. the fuel rail should have welded fittings not the bolt on ones they supply. The supplied throttle body is a jap/generic ebay special, and the welds on the manifold are a little cold in places but it's not too bad. Still - I'm not sure you should be able to pick faults like this in a £1000 manifold.
If there was a market for them, someone could make money designing something similar and selling at a much lower cost.
The dp exhaust manifold can suck donkey dick though. Never seen a straight one from the factory, and again, not something I want to repair before fitting...
Hybrid Mode
