hi there matey - i fitted mine with no prior knowledge in less than an hour which included taking the old one off! basically all i did (on my ph1) was miss out the forward two bolts/nuts and zip tie them to the rad clips (long thing hoppy things that - believe it or not - attach your rad to the slam panel!! Anyway from there, in the kit you usuall get bits of useless velcro (although i think this was from raceland including a free battery cover?) so i used those, stuck one side (X3) to the top half of the air box, then when i was ready to mount the whole lot i simply took the backing off the other half and stuck them into place. This seems to dampen the whole lot. Finally, i got a breather filter for the spare hose your left with that traces back into the inlet manifold and then fabricated a straight bit of solid hosing for the rocker cover breather... For the inlet hosing i chopped the useless bit of rubber hose in half and used the corrogated piping off the original system, that fits snuggly inside the ali pipe on the raceland (air tight on mine - took ten mins haha) and then bought a few more j - clips and tightened it all up - jobs a good un!
if you need pics or any more advice on this mega simple method- please feel free to PM me!
ta - Matt
|
Linear Mode
