| Saxo Problems & Queries If you're having problems with your Saxo and you're after a bit of advice, check this forum out... |
 |
4th April 2010, 22:17
|
#1
|
|
Established Member
Join Date: Jan 2010
Location: Wiltshire
Posts: 1,381
Car(s): Pug 106, Saxo vtr
|
Front Bumper Removal..
Hi guys im just wondering if anyone could tell me how i remove the front bumper from my vtr? Thanks.
|
|
|
|
4th April 2010, 22:19
|
#2
|
|
Regular Poster
Join Date: Dec 2009
Location: Essex, Southend-on-sea
Posts: 381
Car(s): BMW 318 IS
|
You got two torx Screws(20 or 25 I think) one in each wheel arch and two 10 or 13mm bolts underneath those screws..then two bolts at the very front bottom holding it to the slam panel.
__________________
Free Image hosting on my website, Click below
Last edited by Lemmy92; 4th April 2010 at 22:23.
|
|
|
|
|
4th April 2010, 22:23
|
#3
|
|
Established Member
Join Date: Jan 2010
Location: Wiltshire
Posts: 1,381
Car(s): Pug 106, Saxo vtr
|
thanks mate, where abouts are the 2 underneath the front? i dont have arch lining in so should be bit easier (Y)
|
|
|
|
|
4th April 2010, 22:24
|
#4
|
|
Regular Poster
Join Date: Dec 2009
Location: Essex, Southend-on-sea
Posts: 381
Car(s): BMW 318 IS
|
Two at the front..if you look under the front of the car you can't miss them 
__________________
Free Image hosting on my website, Click below
|
|
|
|
|
4th April 2010, 22:27
|
#5
|
|
Infrequent Poster
Join Date: Jan 2010
Location: suttone ely
Posts: 161
Car(s): 1999 vtr black as
and 1.6 si escort 3dr
|
i had some little screw under the font part near where the radiator sits short job unless your rusted up on the slam panel and why you removing your bumper
|
|
|
|
|
5th April 2010, 12:54
|
#6
|
|
Established Member
Join Date: Jan 2010
Location: Wiltshire
Posts: 1,381
Car(s): Pug 106, Saxo vtr
|
Im spraying the bump strip & im going to take it off to do it properly... did the back one yesterday
|
|
|
|
|
7th September 2010, 18:51
|
#7
|
|
L-plater
Join Date: Jan 2010
Location: South Wales
Posts: 43
Car(s): Saxo VTR 02, Calibra C20 XE
|
Fit 21"s that ought to get it off
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT. The time now is 04:33.
|
Linear Mode
