Intermediate driveshaft bearing - Saxperience

thomson_adam · 22nd January 2011, 17:00

here goes .... i have decided to take on the task of putting a new clutch on my mk2 vtr anyhow got the passenger shaft out no problem as i have just changed it but i seem to be stuck on the drivers side. i have roated the 11mm
and should just be able to pull the shaft away but it is stuck quite good. its dark now so i have come in to see if i can get any advice from here. is it a matter of putting a chissle in and trying to slack it off or do i have to have the shaft perfectly straight when pulling it away

madmattracing · 22nd January 2011, 17:04

ive had this problem,i used a lever just by the bearing carrier to ease the bearing out

madmattracing · 22nd January 2011, 17:07

" i have roated the 11mm"
does this mean uve undone both 11mm bolts that hold the bearing in place

thomson_adam · 22nd January 2011, 23:36

Quote:

Originally Posted by madmattracing

" i have roated the 11mm"
does this mean uve undone both 11mm bolts that hold the bearing in place

sorry mate... yeah i have undone both of them then rotated them round. i will try split it tomorrow. have you done the clutch to