west coast to vtr swap, using same ecu?

[Bealesvtr]

Spoke to one of my mates, been told i can use the west coast ecu to run the vtr lump, (using vtr to save money and used to pulling vtr engines apart) its a phase 2 vtr engine, so iv already sourced a phase 2 intake manifold and everything else it comes with including exhaust manifold.

only questions i have are

Will it run okay? as its only a temporary solution until i get a unlocked vtr ecu, as its pre 2000 and single plug would it have to be mapped in a different way as not sure if they have a obd2?

probably had this question loads of times, but i've been scouring the internet over past 3 days trying to find answers before i asked but now given up.

[Chipwizards]

Post a pic of your West Coast ECU, might just be a file swap job and keep the immo intact.

[Bealesvtr]

Picking up car tomorrow afternoon so we be able to get picture then, picking up engine and everything friday, engine swapping it at weekend, ill try and get a picture tommorow night