open the bonnet and at the front of the car is the boonet release catch, follow the bonnet release cable back to wear it meets the bulkhead (the metal wall that seperates the engine bay from the inside of the car)
if you follow the cable you will see where it goes throught the bulkhead which is underneath the bulkhead. It uses a large grommit with a few spare holes. Depending on the thickness of the power cable you may need to cut a bigger slit in the grommit (4 gauge and lower cable) the gommit come out behind the glove box, if you cannot see where poke a metal coat hanger through and attach the cable to it and use some washin up liquid to allow the cable to pass through a little easier.
|
button at the side of the post.
Linear Mode
