Quote:
Originally Posted by LeeM
youve got to use the 1.1 mount on the vtr bracket for the ecu mount i think.
to fit your drivers side shaft you'll have to remove the bracket for the intermediate bearing off the back of the vtr engine block, its a silver ring bolted on that will get in the way of the shaft as its 1 piece on the 1.1
|
Cheers mate, atm I think I can get away with the 1.1 mount, after closer inspection and speaking to J222JRA, I think it should hole till I decide to fit all new bushes
Ah right Will get rid of that over the weekend, as I hopefully will paint it, so just swap that part from the part on the 1.1 engine?
Quote:
Originally Posted by GTuff
jus get everything off the bigger car rad etc will be worth it unless they are shagged
|
Cheers mate, nearly got everything now anyway
Quote:
Originally Posted by jeffchiz
|
Cheers mate, much appreciated, but I think now that if I was going to 16v it, that's when I will have the issues
Threaded Mode