cheers azza!
Ok so ive been a bit confuzzled with plans for this car. so far ive decided on getting it through the mot then moving to the styling s then dropping a VTS lump into it lastly
so plans for the looks are:
smoothed door locks and ariel
buckets and harnesses
supersprint race section
removing the dent on passenger 1/4 pannel
strip it. ie remove rear seats, sound proofing but keep the carpet etc in
then after that the spec i hope to run on a vts lump is
1.6 16v lump under 80k
unlocked ecu
p+p throttle bodie
lightened fly wheel
4-2-1 mani and decat
thats just to start with and will add bits as i go along. before dropping it into the engine tho i hope to replace cambelt, HG, thermostat, oil filter, headbolts and waterpump just so i dont have to strip it down at a later date.
fingers crossed vts engine will be ready by october????
Threaded Mode