Important! : Engine conversion - Saxperience

DPITTS · 22nd July 2010, 13:25

Hi

Where can i get an engine conversion done for me?????

I looked everywhere but cant find anywhere that does it?
people have had it done so where did u get it changed???????

CHeers

Gary-VTR · 22nd July 2010, 13:32

Most people source the parts and do it themselves.

Give KrisB a shout on here. I don't imagine paying to get a 1.1 converted will be cheap though, because the brakes etc will need to be uprated too.

jeffchiz · 22nd July 2010, 13:51

most people buy the parts and then take it to certain members off here to fit it, as mentioned with a 1.1 you are gonna want to change the dampers/springs/wishbones/arb/brakes and preferably the drive shafts as well and if you have a three stud hub you will need to change to 4 stud which also means changing the rear beam, it could be done cheap if you found a vtr/s at the scrappy then id just strip it of the suspension/brakes set up

moxy89 · 22nd July 2010, 14:35

1.1 need the engine mount welding aswell, put me off doing mine